VERTBAUDET TSP169 Manual De Instrucciones página 105

3. Pass the diagonal belt (C) around the back of the car seat. Thread it through the belt
guide (D) at the back, then pass it under the articulation of the handle.
4. Fasten the safety-belt of the vehicle. If the safety-belt is equipped with retractor, pull the
diagonal belt sharply at the level of the retractor in order to block it in place.
(A)
IMPORTANT ! After installation, a minimum distance of 2.54cm should be found
of the car seat.
IMPORTANT ! Always ensure a good installation before use by pulling as hardly as pos-
sible different parts of the safety-belt in order to tighten them to the greatest degree.
HANDLE ADJUSTED TO
(B)
WARNING ! Should you be in doubt of the installaton of the car seat, please
should be twisted.
ADJUSTMENT OF SHOULDER STRAPS
The shoulder straps can be adapted to the size of your child :
As your child grows, it is important to adjust the height of the shoulder
straps. There are 2 levels of openings (Photo 2) for your choice. Schema
1 offers an example of good shoulder straps' position.
WARNING: The height of the shoulder straps must imperatively be adap-
ted to the size of your child. The shoulder straps must project from the
(B)
(C)
POSITION 1
(D)
Schéma 1
EN
(D)