Publicidad
6 MENU DESCRIPTION AND PROGRAMMABLE FUNCTIONS
The control unit has a MAIN MENU and three sub-menus called EXTENDED to personalise programming and the various system functions.
THE "LEV" LED STATUS INDICATES WHICH MENU IS ACTIVE
Pressing the SELECT button several times in succession you can scroll through the menu displayed by the 7 LEDs to choose the desired function
(flashing LED correspondingly flashing) and change its functionality with the SET button (the LED becomes fixed with function enabled or, conversely,
off with function disabled).
The first available menu is the MAIN menu summarized in Tab no. 2:
• Press the SELECT button and select the desired function
MAIN MENU
from the main menu
LIVEL 0 - MAIN MENU
LED
FUNCTION
DESCRIPTION
L1
STEP BY STEP
Selection of the opening
logic
L2
CODE TX
Storage of remote
controls
L3
CONDO
Activate the "Condomi-
nium" function
L4
MOTOR TIME
Storage of the motor
stroke with slowdowns
L5
PAUSE TIME
Automatic closing
setting
L6
DELAY
Adjustment of the delay
between the 2 leaves
L7
AUTO PROGRAM
Self-learning of the stro-
ke with slowdowns
Table 2
The second menu is the one defined as EXTENDED 1 and to access the programmable functions follow the instructions given in Tab. 3:
EXTENDED
• Press the SELECT button and scroll the LED menu until
MENU 1
you reach the LEV LED;
• Press SET once to access the EXTENDED menu 1.
LIVEL 1 - EXTENDED MENU 1
LED
FUNCTION
L1
HOLD-TO-RUN
Hold-to-run input
L2
PEDESTRIAN /SINGLE LEAF
Configuration of pushbuttons
PUSHBUTTON
inputs PP and PPED
L3
PEDESTRAIN BUTTON / DS3
Configuration of the PPED
input as partial opening or as
additional photocell input
L4
PHOTOTEST
Perform the photocell test
before each movement
L5
DS2 STOP IN CLOSE
Configuration of DS2 photo-
cells input
L6
DS1 PARTIAL INVERTION
Configuration of DS1 photo-
cells input
L7
BLOCK / 8K2
Configuration of N.C. STOP or
8.2 K Ohm resistive input.
Table 3
36
COMUNELLO ®Copyright 2019 - All right reserved
Open-Stop-Close-Stop (it closes after the pause time in a partial opening
phase)
TX PP
TX P.PED
After the first one, the other inputs are ignored during the opening and the
pause time
Stored stroke
Automatic closing period stored
Door delay enabled (Not resettable)
Memorized self-learning of the stroke
DESCRIPTION
Enabled function
Opening and closing with two
different buttons
PP: Open / Close button
PPED: Single leaf
Configuration of N.O. PPED input as DS3 N.C. photocells
input (inversion in OPEN)
Enabled function
STOP in CLOSE once the contact is open, then reversal
Partial reversal in CLOSE
8.2 K Ohm resistive input configuration
The LEV function LED stays on FIXED:
LED ON
TX 2CH AUX.
The LED of the LEV function FLASHES with this frequency
LED ON
Disabled function
Leaf with partial / pedestrian
Partial opening/pedestrain leaf
opening
PP: Start / Stop
PP: Open / Close
PPED: partial open of MOT1
PPED: partial opening
Configuration of the PPED input
as N.O. Pedestrian input
Disabled function
Reversal in CLOSE
Complete reversal in CLOSE
N.C. STOP pushbutton
LED OFF
DEFAULT
Automatic (Open-Close)
Empty storage
Disabled function
30 seconds, without
slowdown (default)
Disabled function
Door delay disabled
Disabled function
LED OFF
DEFAULT
Publicidad
