Adjusting The Fork - Husqvarna TE 250 2011 I.E. Instrucciones De Uso

ADJUSTING THE FORK

a) COMPRESSION (TC-TXCi: LOWER REGISTER; TE: UPPER REGI-
STER)
Standard calibration : -9 clicks (TC-TXCi);
Standard calibration : -13 clicks (TE)
To reset to the standadr calibration turn register (A) clockwise
until the position of fully closed is reached then, turn back by
the mentioned clicks. To obtain a smoother braking action, turn
the register anticlockwise. Reverse the operation in order to ob-
tain a harder action.
a)
D
EN - 36
b) EXTENSION (TC: LOWER REGISTER; TE: UPPER REGISTER)
Standard calibration : -15 clicks (TE);
Standard calibration : -13 clicks (TC-TXCi).
To reset to the standard calibration turn register (C) clockwi-
se to reach the position of fully closed; then, turn back by the
mentioned clicks. To obtain a smoother braking action, turn the
register anticlockwise. Reverse the operation in order to obtain
a harder action.
c) AIR VENT (to carry out after each competition, or monthly).
Set the motorcycle on a central stand and release the fork fully
and loosen the air vent valve (D). Once this operation is over,
tighten the valve.
WARNING: Never force the adjusting screws
beyond the maximum opening and closure
positions.
b)
C
A
TC
OIL FORK LEVEL
For the regular fork operation, both legs must be provided with
the necessary oil quantity. Remove the forkrods form the fork to
check the oil level inside the forkrods. Work as follows:
- remove the power rod caps;
- remove springs from the stems letting the oil drop into the
latter;
- bring forks to stroke end;
- check that the level is at distance of 140 mm(5.5 in.) below
the upper limit of rods.
OIL QUANTITY IN EACH FORK LEG
- TC-TXCi: 352 cm
3
- TE: 646 cm (39.4 cu. in.)
3
a)
A
TC - TXCi
(21.5 cu. in.)
TE