Handlebar Position And Height Change - Husqvarna TE 250 2011 I.E. Instrucciones De Uso

NOTE
Flexibility index for the serial springs:
K=8,8 N/mm (TC-TXCi)
K=89,2 N/mm (TE)
NOTE
Always replace both the spring and the spacers to keep the pre-
load value unchanged.
b)
C

HANDLEBAR POSITION AND HEIGHT CHANGE

The handlebar position (a) and height (b) can be changed for
better suiting Your driving requirements. To effect these opera-
tions, remove the upper clamp (1) and the lower one (2), after
removing the fixing srews (3) and (4).
a) Handlebar position change
Turn the lower clamp (2) 180° to move forward or backward
(10mm- 0.04in.) the handlebar position with respect to the
original setup.
A
D
TE
b) Handlebar height change
Remove the lower spacer (A) then replace the screw (4) with a
new one of L=65 mm (2.56 in.) height.
Once these operations are completed, tighten the screws (3) to
2,75-3,05 kgm (27-30 Nm; 19.9-22 Lb/fts) and the screws (4)
to 2,0-2,2 kgm (19,6-21,6 Nm; 14.5-15.9 Lb/fts).
1
4
3
2
1
3
2
A
EN - 37