Saw Blade Change - HOLZMANN MASCHINEN KAM215EPSV Instrucciones De Servicio

The pre-milling cutters should be assembled according to the following position to
receive good milling performance.
17.2.3

Saw blade change

Saw blades have sharp edges. Use cut-resistant gloves to prevent injuries
HOLZMANN MASCHINEN GmbH
NOTICE
CAUTION
www.holzmann-maschinen.at
CLEANING, MAINTENANCE, STORGE, DISPOSAL
1. remove the milling cutter cover / dust
colector hood:
To do this, loosen the two screws (2)
and remove the cover (1)
2. loosen the fixing screw:
Loosen and remove the fixing screw (3)
with a wrench and hold it in the notch on
the milling cutter with a second wrench
or screwdriver so that the screw can be
loosened.
3. remove milling cutter
Remove the milling cutter from the shaft
and clean the entire unit from milling
dust
4. insert new cutters and reassemble them.
In order to re-assemble and tighten the
screws (3), a tool (5) must be used to
hold them in place again.
Loosen the nut (1) and fix the saw blade in
position with a screwdriver.
Remove nut (1), flange (2) and saw blade from
the shaft.
Clean the unit and place a new saw blade on the
shaft:
NOTE: Ensure that the saw blade is running in
the correct direction.
Mount the flange (2) and fix it with the nut, and
for that purpose fix the saw blade in position
again with a screwdriver. (recommended torque
25Nm).
52
KAM215EPSV