Impecca IPAC-08NR Manual De Usuario página 12

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

2. Verify that the partition and base plugs are properly inserted.
3. Ensure the electrical outlet is properly grounded.
4. Check that the air filters are properly inserted and clean as needed.
5. Connect the power cord to a grounded electrical outlet.
6. Insert batteries into your remote control.
DURING REGULAR OPERATION
1. Clean filters regularly using the above instructions.
2. Empty the internal water collection tank or verify the proper operation of the con-
tinuous drain system.
AFTER THE LAST SEASONAL USE
1. Drain the internal collection tank and entire system by opening both the partition
plug and the base plug.
2. Dry out the interior of the unit by running the unit in Fan mode for at least 30 minutes.
3. Reinsert the partition and base plugs.
4. Turn the unit off and unplug the power cable.
5. Clean the air filter screen and reinsert it.
6. Clean the unit exterior if necessary. Use plastic or a towel to cover the unit and
prevent the accumulation of dust and dirt inside the unit.
7. Remove the batteries from the remote control to avoid battery leakage.
NOTE: It's important to regularly clean the air filter unit as heating and cooling performance
is significantly affected by a dirty filter. Dirty filters also substantially increase energy con-
sumption (your electric bill) and the unit is noisier during operation.
TROUBLESHOOTING
PROBLEM / POSSIBLE CAUSES
The air conditioner does not function at all
• Is the power cable properly inserted into a functioning, grounded outlet?
• Is there a power failure such as a blown fuse or tripped circuit breaker?
• Is the timer set to "TIMER ON" mode? Disable the timer to immediately start op-
erations.
• Is the internal collection tank or partition drain full/blocked and the FULL light
illuminated? Empty the tank.
• Is the ambient temperature lower than 61°F (16°C)? A safety device prevents the
unit from cooling the room to even lower temperatures.
Heating or cooling is insufficient
• Is the room temperature set properly?
• Is air filter dirty?
–10–

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ipac-11nr

Tabla de contenido