Keys Statement; Operation - Baxtran DSN Manual De Usuario

4.

KEYS STATEMENT

1. Calibration: for single-point and multi-point calibration
2. Unit: for multiple units selection
3. Count: for simple count
4. Tare: for deduction of the tare
5. Clear: for clearing the input figure, accumulation and alarm records
6. Accumulation: for accumulating the total weight.
7. Zero: for clearing the slight weight to zero
8. Backlight: for conversion between the no backlight and backlight.
9. Confirm: for conforming the set value.
10. Accumulation
11. Alarm preset: for set the weight in a certain range to alarm
12. Increase by degree: 0-9 progressively increasing keys.
13. Leftward: moving to the left
14. Rightward: moving to the right

5. OPERATION

HORIZONTAL ADJUSTMENT
The level of the scale should be checked firstly. Adjust the four feet to center the bubble on the scale.
WEIGHING
Turn the scale on. The display screen will show number 0 after self-testing. Put the commodity on the scale, and the display will show its
weight and a stable signal"o".
ZERO
When no product or slight weight on the scale, you can press
TARE
Place the container you need to deduct the tare on the scale and then press the
weight illustrated is the net weight of the product.
TARE PRESET
If knowing the tare of the product in advance, press the key
then 000000. And then press keys
display shows the negative pre-deducted value. At this time, the machine will automatically deduct the tare. Pressing
the preset tare.
Eg: suppose pre-deducted weight is 1200g, at this moment, the display shows 00000"0"g.
Press the "leftward" for four times and the display shows 00"0"000g.
Press the "accumulation" once and the display shows 00"1"000g.
Press the "rightward" once and the display shows 001"0"00g.
Press the "accumulation" twice and the display shows 001"2"00g.
COUNT
Place the sample product at the number of ten, or twenty, or fifty, or hundred on the scale. Press
the corresponding C10 C20 C50 or C100. Then you can put the product for counting. For back out from the counting mode, press the
for a long time until the display shows preset information "PrE" first and
, and to input the known product value. Then press
back to zero.
. Put the commodity on its container, after that, the
USER'S MANUAL DSN
for confirmation. After that, the
again can clear
after the machine's stable to choose
EN
13