Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
nonstoply.
ACCUMULATION
In the weighing mode, after the machine's stable, press the
and then the accumulating total weight. In the zero point, pressing the
lating contents; you can clear the accumulated records by pressing
ALARM PRESET
Under the weighing mode, if it's necessary to set the upper& lower limit to alarm automatically, press
"H1" and after it shows "0"00000g. Press
limit set. After the weight display illustrates the lower limit set information "-Lo-", it shows "0"00000g. Press
lower limit set value and press
When the weight is in the range of the preset upper and lower limit value, the buzzer will make the alarm of "Dididi"(note: when the upper and
lower limit value is zero , the preset alarm is invalid. Ex: suppose the preset upper limit value is 2200g (the same as the lower limit preset)
Press the "rightward" for three times and the display shows 00"0"000.
Press the "increase by degree" twice and the display shows 00"2"000.
Press the "rightward" once and the display shows 002"0"00.
Press the "increase by degree" twice and the display shows 002"2"00.
CALIBRATION
Turn on the scale by pressing and holding the
as 0300"0"(30000g).Press
glittering, and put the corresponding weight. Load the weight and press
the weight value of the single-point calibration should be above the 70﹪ of the full value).
UNIT SELECTION
Press
to choose the desire unit such as g, kg, ct, dwt, oz, lb and so on. The set unit will be automatically stored when turning the machine
on next time.
BACKLIGHT OPERATION
1. Two backlight modes are available here:"No backlight"mode and"auto-backlight mode. The"No backlight"will never show the backlight under
any condition. The "auto-backlight"mode will light up the backlight when any key is pressed or when the weight on the scale is more than
5d.Five seconds later, the light will extinguish after the weight comes to"0".
2. On weight mode, you will enter into the other backlight mode by keeping pressing Backlight Key [
automatically keep the backlight mode set previously when you turn the scale on again.
BATTERY
When the under voltage indicator is glittering, it shows the insufficient power and you need to recharge it in time. Connect to the power supply
to make the AC indicator light up. This stands for it's charging now. The average charging time is 12 hours.
ELECTRIC QUANTITY INDICATION
1. When the under voltage glitters, it shows the insufficient power and need recharging in time.
2. If the display screen does not show or shows "Lo",this means The battery is in the self-protection state, and you should charge it in time and
then you can use it.
6. MENU SET
Press and hold
to enter Menu set. The display firstly shows the set information and then the value. Press
Press
for confirmation to enter the next set .the scale will automatically back to the original after finishing set.
14
,
and to input the upper limit value, and for confirmation press the
again for checking. (Note: the upper limit set value must be higher than the lower limit value).
until the display shows "CAL". In a few seconds will display the current calibration value such
,
and
to input the calibration value and press
for weight accumulation. The display screen first shows the accumulated times
can read the accumulating contents. During the display of accumu-
.
to confirm. At this moment, the calibration value is
when it is stable, the single-point calibrations is done. (Requirement:
USER'S MANUAL DSN
. The display shows upper information
to enter the lower
,
and
]. After setting the mode, the scale will
to choose the desire value.
EN
to input the
Publicidad
Tabla de contenido
