IKA RV 10 control Instrucciones De Manejo página 13

Mounting the glassware
Note: Observe "Drawings for mounting the glassware" on page 105.
Item Designation
RV 10.1 non-coated
Receiving flask
1
Clamp (stainless steel)
2
Stopcock
4
Pipe tube
5
Condenser 1 Vertical condenser
6
Connection 1 Vacuum connection
7
Clamp (plastic)
8
Evaporation flask 1000 ml
10
Ball joint clamp RV 05.10
11
Screw joint cap
12
Hose connection
13
Manifold
14
Cover cap
15
Cartridge
16
Ring, slotted
17
Washer
18
O-ring
19
Plug, high vacuum
20
Note:
The PTFE tube (5) with the washer (18) can be mounted optionally on the vertical glass sets.
It serves for filling the evaporator flask when there is a vacuum in the glass set.
Solvent can be sucked through the PTFE tube into the evaporator flask by opening the stopcock (4).
Mounting the washer
Note: Pay attention to the correct position of the washer.
Removing the condenser
• Use the ring spanner provided to loosen union nuts that are
tightly fitted.
• Loosen the union nut by turning counterclockwise.
• Remove the Velcro ® .
Note: Ring spanner is only used for removing the condenser,
while fixing the condenser please use hands.
RV 10.2 non-coated
RV 10.10 coated RV 10.20 coated
1 1
1 1
1 1
1 -
1 Diagonal condenser
1 Introduction sleeve
1 1
1 1
1 1
4 4
4 4
- -
- -
- -
- -
1 -
- -
- -
Drainage washer
Quantity
RV 10.3 non-coated RV 10.4 non-coated
RV 10.30 coated RV 10.40 coated
1 1
1 1
1 1
1 1
1 Vertical-intensive 1 Dry ice condenser 1 Vertical condenser 1 Vertical-intensive
condenser
1 Vacuum connection -
1 -
1 1
1 1
4 2
4 2
1 -
- 1
- 1
- 1
1 1
- 1
- -
RV 10.5 non-coated RV 10.6 non-coated
RV 10.50 coated RV 10.60 coated
1 1
1 1
1 1
1 1
condenser
1 Vacuum connection 1 Vacuum connection
1 1
1 1
1 1
4 4
4 4
1 1
- -
- -
- -
1 1
- -
1 1
13