Commissioning - IKA RV 10 control Instrucciones De Manejo

Working screen at the time of delivery
The start screen appears for a few se-
conds after the device is switched on. The
device name and the software versions
are displayed.
An information prompt then appears to
download the IKA firmware update tool.
Explanation of symbols on the working screen
The symbols displayed change depending on the status and set-
tings of RV 10 auto.
Symbol Designation
Bluetooth
®
USB
Limit
Temperature sensor
PC control
Program controlled
Rotation
Drying
Flow rate
Cooler connected
Venting
Vacuum
Detecting
Boiling
16

Commissioning

Description
This symbol means the RV 10 is communicating via Bluetooth
longer appears if no Bluetooth
This symbol means RV 10 is communicating via a USB cable. The symbol no longer appears if no
USB cable is being used for communicating with the station.
This symbol indicates if a minimum or maximum limit of a set value is reached.
This symbol appears when the temperature display is active in the display.
This symbol means that device is connected to a computer and that it is being controlled by the
computer.
This symbol means that device is being controlled by a program.
This symbol indicates that the rotation is in continuous mode and indicates the direction of rota-
tion.
This symbol indicates that the drying option was selected (only in 100 % mode).
This symbol indicates that a fluid (water) is running through the system.
This symbol indicates that a cooler is connected and running.
This symbol indicates that the venting valve is open. If this symbol is not shown the venting valve
is closed.
This symbol indicates that the pressure inside the RV 10 system is lower than the atmosphere
pressure.
This symbol is shown during the automatic evacuation mode.
This symbol indicates that a boiling point was found (only in automatic mode).
After this, the working screen appears automatically on the dis-
play.
® communication is being performed.
with a PC or tablet. The symbol no
®