Puky YOUKE 12 Manual De Instrucciones página 17

SETTING THE BRAKES:
(V - BRAKE)
The bicycle has two calliper brakes. The left brake
lever operates the brake on the front wheel, the right
brake lever operates the brake on the rear wheel.
Depending on the model, the bicycle may also have a
back pedal brake for the rear wheel.
To set the brake you will need the following tools.
(The tools are not part of the scope of delivery.)
• Crosstip screwdriver
1. Centre the brake arms by turning the adjusting
screw.
The gap between the brake pad <-> rim should
be identical on both right and left and the contact
between brake pad/rim should be applied simultane-
ously on both sides when you brake.
BRAKE LEVER AND TENSION
12'' – 18''
To set the brake lever and tension you will need the follow-
ing tools.
(The tools are not part of the scope of delivery.)
• Crosstip screwdriver
GB
43836_kinderfahrrad_148x210.indd 17 43836_kinderfahrrad_148x210.indd 17
You will need a cross-headed screwdriver. By turning
the screw in, you move the appropriate brake arm
away from the rim, turning the screw out moves the
screw towards the rim.
1
1. The handle distance (distance of brake lever to
handlebar) can be adjusted individually using an
cross-headed screwdriver on the brake handle.
Please remember that braking must taken effect
before the brake lever reaches the handlebar!
1 1
It is important that the brake levers are actuated
several times so that the tension of the brake arms
is evenly distributed to both sides and the settings
2
2. The tension can be set on the brake handle using
the knurled screw.
The brake is set correctly if the brake pads are all
approximately 1.5 mm from the rims.
+
+
_
take effect.
17
09.06.2020 07:50:27 09.06.2020 07:50:27