Declaration; Ec Declaration Of Conformity - Pratissoli MF Serie Manual De Uso

17

DECLARATION

The manufacturer INTERPUMP GROUP S.p.A. - Via E. Fermi, 25 - 42049 - S. ILARIO D'ENZA - Italy DECLARES that the product
identified and described as follows:
Name: Pump
Type: Reciprocating plunger pump for high pressure water
Trademark: INTERPUMP GROUP
Model: MF45 - MF50 - MF55
Is found to comply with the Machinery Directive 2006/42/EC
Standards applied: UNI EN ISO 12100:2010 - UNI EN 809:2000
The pump identified above meets all the essential safety and health protection requirements as listed in section 1 of Annex I of
the Machinery Directive:
1.1.2 - 1.1.3 - 1.1.5 - 1.3.1 - 1.3.2 - 1.3.3 - 1.3.4 - 1.5.4 - 1.5.5 - 1.6.1 - 1.7.1 - 1.7.2 - 1.7.4 - 1.7.4.1 - 1.7.4.2 and the relevant technical
documentation has been compiled in accordance with Annex VII B.
In addition, the manufacturer undertakes to make available, following a reasoned request, a copy of the relevant pump technical
documentation in the manner and terms to be defined.
The pump should not be put into service until the plant to which the pump is to be incorporated has been declared in
accordance with the provisions of the relevant directives and/or standards.
Person authorised to compile the technical file
Person authorised to draw up the declaration:
Reggio Emilia - December 2012
Only for pumps ordered with the ATEX configuration
The manufacturer INTERPUMP GROUP S.p.A. - Via E. Fermi, 25 - 42049 - S. ILARIO D'ENZA - Italy DECLARES that the pumps
identified and described as follows:
Name: PUMP
Type: Reciprocating plunger pump for high pressure water
Trademark: INTERPUMP GROUP - PRATISSOLI
Models: MF45 - MF50 - MF55
marked with group II, category 2 GD, ck protection and temperature class T4/T135°C, when ordered as ATEX pumps,
are in conformity with the ATEX Directive 94/9/EC and can be used in potentially explosive atmospheres within the limits of
classified areas, in compliance with the declared performance and installed and used in accordance with the guidelines of this
manual, of the general manual and/or the specific manual of each pump.
The manufacturer uses all measures necessary to ensure that the pumps are produced in accordance with the statements.
European standards applied:
UNI EN 1127-1:2011; UNI EN 13463-1:2009; UNI EN 13463-5:2011; UNI EN 13463-8:2003
The technical file is deposited at DNV ITALIA (N° 0496)
Person authorised to draw up the declaration:
Reggio Emilia - February 2014
DECLARATION OF INCORPORATION
(In accordance with Annex II of European Directive 2006/42/EC)
Name: Maurizio Novelli
Address: INTERPUMP GROUP S.p.a. - Via E. Fermi, 25 -
CEO Ing. Paolo Marinsek

EC DECLARATION OF CONFORMITY

(In accordance with Annex X of European Directive 94/4/EC - ATEX)
CEO Ing. Paolo Marinsek
42049 - S- ILARIO D'ENZA (RE) - Italy
Signed:
Signed:
31