Skil 3510 Instrucciones De Funcionamiento página 12

3510 2610008262 ENG:SM 2610008262 12-09 3/26/10 9:03 AM Page 12
CUTTING LINE GUIDE
For a straight 90° cut, use left side of notch in
the foot. For 45° bevel cuts, use the right
side (Fig. 8). The cutting guide notch will give
an approximate line of cut. Make sample cuts
in scrap material to verify actual line of cut.
This will be helpful because of the number of
different blade types and thicknesses
available. To ensure minimum chipping or
splintering on the good side of the material to
be cut, face the good side down.
ATTACHING THE WATER SUPPLY
The
CAUTION
!
supplied with this saw is a
wet type. You must use water when cutting
with the supplied blade. If water is not
used, blade may overheat and cause
premature blade failure.
Connect the hose adapter from the water
supply line to a garden hose or a faucet with
the correct fitting and tighten securely. Turn
on the faucet that the supply line is
connected to. Do not turn the faucet on high.
Turn the water supply valve clockwise to the
ON position to start the flow of water. To turn
the water off, turn the valve counterclockwise
to the OFF position. You can adjust the flow
of water by turning the valve either clockwise
or counterclockwise between the ON and
OFF positions. When finished cutting, turn
the water off.
When starting the tool,
WARNING
!
hold it firmly in your hand.
The torque from the motor can cause the tool
to twist.
To turn tool on, push in the switch lock button
and squeeze the trigger switch. To turn the
tool off, release the trigger switch, which is
spring-loaded and will return to the OFF
position automatically.
diamond blade
SWITCH
45°
BEVEL
CUTS
90°
VERTICAL
CUTS
WATER
OFF
Your saw should be running at full speed
BEFORE starting the cut, and turned off only
AFTER completing the cut. To increase
switch life, do not turn switch on and off while
cutting.
-12-
Fig. 8
Fig. 9
WATER
ON