Replacing The Battery - Snuza HERO Manual De Instrucciones

9.3 Replacing the Battery

For all SE models: use a CR2 (CR15270) battery available from most retail outlets.
For all other models: use only a 14250 battery that delivers 3V 600mAh, available
from a specialist battery supplier or your national Snuza distributor (please see our
website www.snuza.com for information about batteries and details of your national
distributor.
** The serial number is located inside the battery housing (it can also be found on the
original Snuza packaging). To locate the serial number, remove the battery cover and
battery as per the instructions below:
1. Use your fingernail or a small flat implement. With a pinching
action (Figure 1), gently pull back the Battery Cover Release
Clip (10) on the underside of the monitor and lift the Battery
Cover at the same time (Figure 2).
2. The Clip Guard Rail (11) prevents the clip from bending too
far. Do not try to bend the clip beyond this point.
3. Remove the depleted battery. The serial number is located
beneath the battery.
4. Insert the new battery, negative end first, as shown in Figure 3.
Ensure that the polarity is correct (align the positive end '+'
of the battery with the '+' symbol in the battery housing).
Replace the Battery Cover and ensure that it is correctly
closed (Figure 4). Do not use the monitor without the
Battery Cover in place.
5. Test the unit by switching on and ensuring that the Battery
Indicator Light (2) flashes green.
6. If the unit starts emitting a beep after the battery has been
replaced, simply press the ON/OFF and MODE/OFF buttons
simultaneously to turn it off.
HERO manual-TYPE 1-06.2015.indd 14
14 14
2015/07/06 5:41 PM