Fitting Your Snuza; Fitting Your Hero; Operation; Startup - Snuza HERO Manual De Instrucciones

6. FITTING YOUR SNUZA

When attaching Hero to the diaper, put your fingers between the diaper and baby's
skin in order to make sure that you do not trap baby's skin in the clip.
Ensure that the Battery Cover (9) is
secure. Clip your Hero all the way onto
the diaper to the full extent of the clip,
as shown:
Make sure that the Movement Sensor
(1) is in contact with the baby's tummy
around the belly button area, although
closer to the sides may suit different
sleeping positions.
* The soft sensor tip on the monitor is
made from medical grade silicone and
is hypoallergenic. In the unlikely event
that a red friction mark is noticed on
the baby's skin where the monitor was positioned, then we recommend that a thin
layer of clothing is placed between the baby's skin and the monitor. The position of the
monitor must also be changed to a different location on the tummy, away from where
the red mark was noticed and preferably closer to the side.
The World Health Organisation (WHO) recommends that babies be placed to sleep on
their back unless advised otherwise by a doctor.

7. OPERATION

7.1 Startup

Switch on by briefly pressing the ON/OFF button (6).
A startup-test will run which will turn on (in sequence) all indicator lights, vibration
stimulator and audible alarm. The Battery Indicator Light (2) will flash briefly as follows:
HERO manual-TYPE 1-06.2015.indd 9
Green
Battery OK
Orange Battery nearing depletion – replace battery
Red Battery flat – Hero will not monitor, replace battery
9 9
2015/07/06 5:40 PM