Quick Start Guide; Diaper/Nappy Fitment - Snuza HERO Manual De Instrucciones

4. QUICK START GUIDE

1. Important: Use the correct diaper size and make sure it fits snugly (see Section 5

Diaper/Nappy Fitment ).

2. Switch on by briefly pressing the ON/OFF button (6).
3. A start-up test will illuminate the indicator lights, vibrate the stimulator, play the
start-up tone and perform a battery test.
4. Clip Hero onto the diaper so that the Movement Sensor (1) is in direct
5. The Movement Indicator Light (3) flashes on each abdominal movement. See
6. If abdominal movement is not detected for 15 seconds, the vibrating stimulator will
7. If further abdominal movement is detected within 5 seconds after a vibration, the
8. After three vibrations, the Rouse Warning is activated – Hero beeps every 2
9. If the period of no abdominal movement reaches 20 seconds, the full audible
10. The alarm can be deactivated by briefly pressing the MODE/OFF button (7) and
11. To switch off the monitor, press both the ON/OFF (6) and MODE/OFF (7) buttons
5. DIAPER/NAPPY FITMENT
Important: Correct diaper fitment is
essential for the operation of Hero. The
thin flap of material at the top of the
diaper must be folded over the thicker
part before the diaper is closed (this is
the section to which Hero will be attached). The diaper should fit snugly on the baby
with the top of the diaper just below the belly button. Loose fitting diapers will gape,
causing the monitor to lose contact with the baby and false alarm. A very 'full' or wet
diaper may also cause it to gape.
HERO manual-TYPE 1-06.2015.indd 8
contact with the baby's tummy (see Section 6 Fitting your Hero).
Section 7.2 Monitoring for a full description of what it signifies.
attempt to rouse the baby.
Movement Indicator Light (3) will flash red to indicate that there has been a
15-second period of no abdominal movement.
seconds and the Movement Indicator Light (3) flashes red with every beep.
alarm will sound and the Alarm Indicator Light (4) will flash red.
monitoring will continue.
simultaneously. A shutdown tone will be heard.
8 8
2015/07/06 5:40 PM