Sears Kenmore Elite 66442783710 Instrucciones De Instalación página 19

13. Verify that the anti-tip bracket is installed and engaged.
a. Use a flashlight to look underneath the bottom of and
behind the range.
b. Visually check that the rear range foot is inserted into
the slot of the anti-tip bracket.
14. Rotate blower motor cover so the bellows are in their final
position. Ensure the rear of the bellow flange is engaged in
the retaining bracket.
Rotate cover
Retaining bracket
15. Secure the front of the blower bellow flange to the range
frame with the supplied #8-18 x 3/8" (9.5 mm) screw.
Connect Blower Electrical Parts
1. Locate the capacitor (in Blower Motor Kit).
NOTE: The capacitor is supplied with a small harness that
terminates in a two-pin connector as shown.
Post 1
2. Locate the capacitor storage tray in front of the blower
below connection point in the lower right side of the range.
3. Place capacitor in tray.
Final position
Screw
Post 2
Capacitor
storage tray
4. Secure the capacitor with the capacitor retention bracket,
then install the bracket screw.
5. Secure the blower motor strain relief, near the quick
connection end, to the blower electrical terminal cover with
the two provided screws.
6. Locate the 2-pin connector on the blower motor wire
harness and connect it to the two-pin capacitor connector.
7. Locate the 4-pin connector on the blower motor wire and
plug it into the terminal connection point directly behind
the capacitor storage tray.
NOTE: The terminal release (clip point) will be facing
toward the front of the range.
Retention
bracket
19