Sears Kenmore Elite 66442783710 Instrucciones De Instalación página 24

3. Unscrew the metal cover and unscrew the blue regulator
cap. Keep the washer in place.
A
A. Metal cover
B. Washer
C. Blue regulator cap
4. Flip the blue regulator cap over and screw it back into the
metal cover.
A
A. Natural gas position
B. Propane gas position
5. Screw the metal cover securely back into place. Do not
overtighten.
To Convert Surface Burners (Natural Gas to
Propane Gas)
1. If the burner grates are installed, remove them.
2. Remove burner cap.
3. Remove the burner base.
A
A. Igniter electrode
B. Burner cap
C. Gas tube opening
D. Burner base
4. Apply masking tape to the end of a 9/32" (7 mm) nut
driver to help hold the gas orifice spud in the nut driver
while changing it. Press nut driver down onto the gas orifice
spud and remove by turning it counterclockwise and lifting
out. Set gas orifice spud aside.
B
A
C
A. Igniter electrode
B. Orifice spud
C. Orifice spud holder
D. Screws
24
5. Remove the orifice spuds shipped in the literature package
in the oven. Gas orifice spuds are stamped with a number,
marked with 1 or 2 color dots, and have a groove in the hex
area. Replace the Natural gas orifice spud with the correct
Propane gas orifice spud.
B
Refer to the following chart for correct Propane gas orifice
spud ratings and to spud holder card for proper placement.
Propane Gas Orifice Spud Chart for Surface Burners
Burner
Rating/Type
15,000 BTU/
Stacked*
14,200
BTU/Ultra/
Stacked*
B 8,000 BTU/
Semi
5,000 BTU/
Auxi
1,200 BTU/
Stacked/
Simmer*
* Not in all kits/models
NOTE: Refer to the model/serial/rating plate located on
the oven frame behind the top left-hand side of the oven
door for proper sizing of spuds for each burner location.
6. Place Natural gas orifice spuds in the orifice spud bag.
B
IMPORTANT: Keep the Natural gas orifice spuds in case
of reinstallation with Natural gas.
C
7. Replace the burner base.
D 8. Replace burner cap.
9. Repeat steps 1 through 7 for the remaining burners.
D
A
A. Propane groove
Color Size ID
(mm) number
Silver 1.05 L105
Black/Orange 0.32 L32
Silver 1.05 L105
Red/Orange 0.85 L85
Red/Blue 0.65 L65
Black/Orange 0.32 L32
Placement
RF
LF/RF
RR
LR
LF
(Simmer)