Verify Anti-Tip Bracket Is Installed And Engaged; Electronic Ignition System - For Dual Fuel Models Only - Sears Kenmore Elite 66442783710 Instrucciones De Instalación

8. Install blower electrical terminal cover.
NOTE: When replacing cover, insert the terminal cover
tabs in the corresponding slots in the range, and push the
terminal cover rearward to engage.
9. Install terminal cover screw.
10. Replace the access panel by aligning the studs with the
keyhole slots on the range. Press the access panel forward
into the slots and push downward to engage the studs.
11. Reconnect power.
20
2
2
Verify Anti-Tip Bracket
Is Installed and Engaged
1. Ensure range is in its final location.
2. Remove the front lower access panel.
3. Use a flashlight to look underneath the bottom of the
range.
4. Visually check that the rear range foot is inserted into the
slot of the anti-tip bracket.
5. Replace the front lower access cover.
IMPORTANT: If the range is moved to adjust the leveling legs,
verify that the anti-tip bracket is engaged by repeating steps
1 to 5.
Electronic Ignition System – For Dual
Fuel Models Only
Initial Lighting and Gas Flame Adjustments
Cooktop and oven burners use electronic igniters in place of
standing pilots. When the cooktop control knob is turned to
Lite, the system creates a spark to light the burner. All cooktop
burners will spark, but only the burner with the control knob
turned to Lite will produce a flame. This sparking continues as
long as the control knob is turned to Lite.
When the oven control is turned to the desired setting,
sparking occurs and ignites the gas.
Check Operation of Cooktop Burners
Standard Surface Burners
Push in and turn each control knob to LITE.
The flame should light within 4 seconds. The first time a burner
is lit, it may take longer than 4 seconds to light because of air
in the gas line.
If Burners Do Not Light Properly:
Turn cooktop control knob to OFF.
■
Check that the range is plugged into a grounded 4 prong
■
outlet. Check that the circuit breaker has not tripped or
the household fuse has not blown.
Check that the gas shut-off valves are set to the open
■
position.
Check that burner caps are properly positioned on burner
■
bases.
Repeat startup. If a burner does not light at this point, turn the
control knobs to OFF and contact your dealer or authorized
service company for assistance. Please reference the back
cover of the Use & Care Guide to contact service.
If the cooktop low burner flame needs to be adjusted for any
of the burners, see the "Adjust Flame Height" section.