Inserting The Motor Into The Bearings; Assembling The Shutter Curtain; Mounting The Roller Shutter Stopper Or An End-Rail - RADEMACHER 2540 06 36 Instrucciones De Montaje

Inserting the motor into the bearings ( Figure  )
1.
Drive end bearing (click bearings)/(13)
Push the drive head (12) gently into the drive end bearing (13) until
it clicks into place.
NOTE
The set button (11) must be easily accessible.
The tubular motors can be installed in 4 positions in the click bearings (13). By
opening the fixing brackets (14), you can release the motors from the new click bearing
(13) at any time.
Drive end bearing (all other bearing types)
Insert the drive head (12) into the respective drive end bearing and secure it accord-
ingly using a linchpin.
Assembling the shutter curtain ( Figure  /  )
Attach the shutter curtain (17) to the winding shaft (5) using the ties (6) (accessories).
STOP
Mounting the roller shutter stopper or an end-rail (Figure 9 )
9
The illustration shows a roller shutter with external stoppers (21), which are installed
on the rails.
Never drill holes or use screws near the
drive when installing roller shutters.
(21)
2.
Counter bearing (1)
Insert the other end of the winding shaft (5) with the ball bearing
(2) into the counter bearing (1).
In case of using a different drive end bearing than the RADEMACHER
click bearing, you need to secure the drive if need be with a second
linchpin.
Minor inside width in-accuracies can be corrected by pulling the roller
3.
cap (4) further out or pushing it further into the winding shaft (5).
IMPORTANT
◆ Secure the roller cap (4) with a screw once installation is completed.
◆ At least 2/3 of the roller cap (4) must be located inside the winding shaft (5).
1. Push the ties (6) onto the top slat of the roller shutter curtain (17).
2. Insert a tie (6) every 40 cm into one of the rectangular openings
on the winding shaft (5).
2.a When using SW40 winding shafts (with exterior rabbet), use hanging
brackets (20) for attaching the ties (6); see figure  .
IMPORTANT
◆ Setting the end points without a stopper (21) or operating the equip-
ment without a stopper (21) may cause the roller shutters to run
into the roller shutter box and be damaged.
The roller shutters (17) must always be fitted with a stopper (21) or end-rail. For this
reason, always mount the respective part before commissioning (see example in
figure 9).
EN
51