5.3. Fitting the cuff
a) Pass the end of the cuff through the metal stirrup
so that a loop is formed. The Velcro closer must
be facing outwards. (Ignore this step if the cuff
has already been prepared.)
b) Push the cuff over your left upper arm so that the
tube points in the direction of the lower arm.
c) Lay the cuff on the arm as illustrated. Make
certain that the lower edge of the cuff lies
approximately 2 to 3 cm (1") above the elbow
and that the tube leaves the cuff on the inner
side of the arm.
Important! The white bar must lie exactly over
the artery which runs down the inner side of your
arm.
d) Tighten the free end of the cuff and close the
cuff with the velcro.
e) There should be no free space between the arm
and the cuff. Clothing must not restrict the arm.
Any piece of clothing which does (e.g. a pullover)
must be taken off.
f) Secure the cuff with the Velcro closer in such a
way that it lies comfortably and is not too tight.
Lay your arm on a table (palm upwards) so that
the cuff is at the same height as the heart. Make
sure that the tube is not kinked.
g) Remain seated quietly for two minutes before
you begin a measurement.
tube
7