Technical Description; Function Description; Operating Elements - Waeco PerfectView LCD250 Instrucciones De Montaje Y De Uso

_RV-250.book Seite 34 Donnerstag, 14. Dezember 2006 4:54 16
PerfectView LCD250
5

Technical description

The rear view system RV-250/LCD consists of a camera and an LCD monitor. The system
is activated when the driver shifts into reverse gear. The camera is attached to the rear of
the vehicle and transmits the image to the monitor on the dashboard via a cable.
You can also install a side camera (e. g. RV-29-T130) in order to see the side areas when
making a turn.
5.1

Function description

Two cameras can be connected to the LCD monitor RV-250 and you can switch back and
forth between them. With one camera you can monitor the rear area and with the other
camera the area on the side.
The LCD monitor can be mounted to the dashboard where it transmits the image of the
connected camera so that the driver is able to see the area behind the vehicle, e. g. when
parking.
5.2

Operating elements

The following control elements are located on the monitor:
No. in 0,
Description
page 6
1 –
2 C1/C2
3 MODE
4 MENU
5 –
6 +
7 C1 (BRI.)
8 C2 (CONT.)
9 COLOR
10 POWER
Description
Both mini switches activate the mirror function
for camera 1 or camera 2.
Switches from camera 1 to camera 2 and vice-
versa.
Reduces the brightness to prevent glare.
Saves the picture settings for each camera.
Switches to setup mode (see chapter "Using the
LCD-monitor" on page 43).
Reduces the volume.
Increases the volume.
This LED is lit if camera 1 appears on the
display.
This LED is lit if camera 2 appears on the
display.
This LED is lit orange if the monitor is operating
in day mode.
It is lit green if the monitor is operating in night
mode.
Switches the monitor on and off.
Technical description
34