Waeco PerfectView LCD250 Instrucciones De Montaje Y De Uso página 41

_RV-250.book Seite 41 Donnerstag, 14. Dezember 2006 4:54 16
Mounting the camera and monitor
7.4 Laying the system cable from the camera to the monitor
➤
Lay the system cable for the camera inside the vehicle.
➤
Lay the system cable for the camera to the monitor.
➤
Connect the monitor connection cable to the system cable.
➤
Insulate the plug connection with the insulating tape supplied. Overlap every layer of
the insulating tape by one half of its width.
➤
Attach the cables securely in the vehicles to prevent tripping hazards. This can be
performed by using cable binders, insulating tape or gluing in place with adhesives.
Note
Only start sealing through-holes when you have completed all installation work
on the camera and have laid the required cable lengths.
7.5 Connecting the rear view system to the power supply
The circuit diagram for the rear view video system is located in h, page 9.
No. in h,
Description
page 9
1 Monitor
2 7-pin mini DIN plug
3 Connection cable
4 7-pin mini DIN socket
5 12 V positive cable (red): Connection to the positive pole of the
voltage source
6 Earth cable (black): Connection to the negative pole of the
voltage source
7 5-pin DIN socket (connection to camera 1)
8 5-pin DIN socket (connection to camera 2)
9 Cable (green): Control input for the connection to the reversing
lights
10 Cable (white): Control input for the connection to the indicators
(side camera)
11 5-pin DIN plug
12 System cable
13 5-pin mini DIN socket
14 5-pin mini DIN plug
15 Camera
Observe the following instructions when laying the connection cable:
41
PerfectView LCD250