Waeco PerfectView LCD250 Instrucciones De Montaje Y De Uso página 42

_RV-250.book Seite 42 Donnerstag, 14. Dezember 2006 4:54 16
PerfectView LCD250
Feed the connection cable through existing ducts or other openings where
possible e. g. ventilation grilles. If no appropriate ducts or openings are
available you will need to drill a hole of
there is sufficient space on the other side for the drill head to come out (2,
page 4).
Please observe the notes from the chapter "General information on the
electrical connections" on page 35.
➤
Lay the monitor cable on the dashboard.
➤
Insert the plug of the monitor cable (h 2, page 9) in the socket (h 4, page 9) of the
connection cable (h 3, page 9).
Make sure the polarity is correct when connecting to a voltage source.
➤
Connect the red and black cables of the connection cables to a suitable
voltage source:
– Connect the red cable (h 5, page 9) to terminal 15 (ignition).
– Connect the black cable (h 6, page 9) to terminal 31 (earth).
➤ If necessary, connect the DIN socket (h 7, page 9) of the connection cable to the
DIN plug (h 11, page 9) of the system cable (h 12, page 9).
➤
Connect the DIN socket (h 13, page 9) of the system cable (h 12, page 9) of to the
DIN plug (h 14, page 9) of the camera cable.
➤
Connect the green cable (h 9, page 9) to the positive cable of the reversing light.
If the green coloured cable is electrically charged, the monitor is automatically
switched on and camera 1 is activated.
➤
If the monitor is to be activated by actuating the indicator, connect the white cable
(h 10, page 9) to the positive cable of the indicator.
➤
If necessary, connect the DIN socket (h 8, page 9) of the connection cable
to camera 2 (e. RV-29-T130).
Mounting the camera and monitor
ý
20 mm. Check beforehand that
42