Medela Harmony Instrucciones De Uso página 8

Before first use, remove and dispose of the protective cover ( ¢6-01) from the breast shield.
Wash and sanitise the pump parts and bottles following the steps 1 to 4 below.
8
Wash your pump parts and bottles after each use and sanitise the parts once per day after
they have been washed.
1. Disassemble
Refer to figure ¢1 on the foldout page.
i. Disassemble the pump into its individual parts (breast shield, connector, handle, valve head and milk
bottle).
ii. Remove the diaphragm from the handle and pull the stem out.
iii. Remove the valve membrane from the valve head.
iv. Separate the milk bottle, lid and bottle stand.
2. Wash
Rinse and wash by hand
i. Rinse the disassembled parts with cool
water (approx. 20 °C).
ii. Clean these parts with plenty of warm,
soapy water (approx. 30 °C). Use a commer-
cially available washing-up liquid.
iii. Rinse the parts with cool water for 10 to 15
seconds (approx. 20 °C).
3. Sanitise (before first use and once per day)
Sanitise on stovetop
Cover the disassembled, washed parts with
water and boil at least for 5 minutes.
4. Dry
Allow to air-dry on a clean, unused dish towel or paper towel. Store the dry parts in a clean environment.
Do not store parts in an airtight container/bag if moist. It is important that all residual moisture dries.
or
or
5 min
*Refer to local website/shops for availability in your country.
Wash in dishwasher
Place the disassembled parts on the top rack
or in the cutlery section. Use a commercially
available dishwashing detergent.
Sanitise in microwave
(except for
the handle)
Use Quick Clean* bags in the microwave in
accordance with the instructions on the bags.