Location And Function Of Parts And Controls - Sony YS-W170 Manual De Instrucciones

Location and Function of Parts and Controls

1
Front
1 POWER switch
Switches the power to the unit and the connected
cameras on and off.
Notes
• If you connect a camera to this unit after switching
the power on, the camera will not operate. Be sure to
complete connections before switching the power on.
• If you switch the power off and want to switch it back
on, wait 10 seconds or more before doing so.
2 LED indicator
Indicates whether a camera has been connected.
3 SYNC MODE switch
You can select the mode according to the
synchronization signal source.
You can switch the synchronization mode according to
the synchronization signals.
PRIMARY: Uses the synchronization signals from
the YS-W170/W170P.
SECONDARY: Uses external synchronization
signals when you connect multiple camera
adaptors, or uses the internal synchronization
signals from the camera.
4 SYNC SYSTEM switch
You can select the mode according to the camera's
synchronization method.
VS: Uses a VS method camera (conventional Video
Sync method).
VD: Uses a VD method camera.
8
(GB)
2
5 4 3
6 7 8 9 0
Rear
5 CABLE COMP (1/2/3) switch
Compensates for signal loss in the cable connection to
the camera. Set the switch depending on the cable type
and length according to the following table.
When using SSC-series cameras
Switch setting
1
Cable type
max. 100 m
RG-59B/U (3C-2V)
(328 ft.)
max. 160 m
RG-6A/U (5C-2V)
(524 ft.)
max. 200 m
RG-11A/U (7C-2V)
(656 ft.)
Caution
The resistance of the cable should be 30 ohms or less.
6 CAMERA IN connector (BNC-type)
Connects to the DC IN.VS IN/VIDEO OUT connector
of any SSC-series camera or the SPT-M320/M320CE
video camera with multiplex transmission capability.
Note
When using a SSC-series camera or the SPT-M320/
M320CE video camera, be careful not to connect the
CAMERA IN connector on the camera adaptor with
the MONITOR OUT connector on the camera; doing
so may lead to damage or breakdown of the camera.
Always be sure to connect to the VIDEO OUT
connector on the camera.
If you are using an SSC series camera, see "Notes on
Connections" on page 10 (GB).
qa
2 3
max. 200 m max. 300 m
(656 ft.) (984 ft.)
max. 330 m max. 500 m
(1082 ft.) (1640 ft.)
max. 400 m max. 600 m
(1312 ft.) (1968 ft.)