df models KL-80 Manual De Instrucciones página 26

Programming:
If you press and hold the set button after starting the programming mode, the green LED will
start to blink once and you are in the first programing step.
If you continue to press the set button, the green LED will blink twice after 3 seconds, the num-
ber of blinking signals will increase by 1 for each additional 3 seconds.
> Hold the set button until you have reached the desired programming step (number of pro-
gramming steps = number of blinking signals of the green LED).
> Release the set button to confirm the desired programming step.
> Press the set button once again.
The red LED will blink once for the first selection option.
> Press the set button again, the red LED will blink twice for the second selection option.
> Press the set button until the number of blinking signal matches the number of the respective
selection option of the according programming step.
Example
1. Programming step
> The green LED blinks once.
You are in the first programming step "operating modes".
> Release the set button to set the first programming step "operating mode".
> The red LED blinks once for the first selection option: operating mode "forward with brake"
> If you want to quit programming here, switch off the speed controller and and restart it
subsequently.
> Or: Press the set button again until you have reached the desired value.
Press the set button twice, the LED button will blink twice: operating mode "forward/reverse
with brake"
Press the set button 3 times, the LED will blink 3 times: operating mode "forward/reverse"
(rock crawler)
2. Programming step:
> Start the programming mode.
> Hold the set button for 3 more seconds after the green LED has blinked once.
> The green LED will blink twice.
You are in the second programming step "drag brake".
> To set the second programming step "drag brake", release the set button and press it again.
> The red LED will blink once for the first selection option: drag brake 0%
> If you want to quit programming here, switch off the speed controller and and restart it
subsequently.
-  -
1102/V1/0110