EHEIM skimmarine300 Manual De Instrucciones página 13

English
R
You are prompted for an action.
2. Application
The appliance and all parts included in the scope of delivery are intended for private use and must only be used:
for the removal of metabolic products in saltwater aquariums up to approx. 300 l
indoors
in compliance with the technical data
The following limitations apply to the appliance:
do not use for commercial or industrial purposes
VERY IMPORTANT SAFETY INSTRUCTIONS
WARNING- To guard against injury, basic safety precautions should be observed, including the following.
FOR HOUSEHOLD USE ONLY
WARNING! RISK OF ELECTRIC SHOCK!
This pump has not been investigated for use in swimming pools areas!
DO NOT RUN DRY!
READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
DANGER. To avoid possible electric shock, special care should be taken since water is employed in the use of
aquarium equipment. For each of the following situations, do not attempt repairs by yourself; return the appliance
to an authorized service facility for service or discard the appliance.
If the appliance shows any sign of abnormal water leakage, immediately unplug it from the power source.
Carefully examine the appliance after installation. It should not be plugged in if there is water on parts not
intended to be wet.
Do not operate any appliance if it has a damaged cord or plug, or if it is malfunctioning or if it is dropped or
damaged in any manner.
POWER
SUPPLY
CORD
DRIP LOOP
13
To avoid the possibility of the appliance plug or recepta-
cle getting wet, position aquarium stand and tank to one
side of a wall mounted receptacle to prevent water from
dripping onto the receptacle or plug. A "drip loop", shown
cord connecting the aquarium appliance to a receptacle.
The "drip loop" is that part of the cord below the level
of the receptacle, to prevent water travelling along the
cord and coming in contact with the receptacle. If the
plug or receptacle does get wet, DON'T unplug the cord;
disconnect the fuse or circuit breaker that supplies power
to the appliance. Then unplug and examine for presence
of water in the receptacle.