EHEIM skimmarine300 Manual De Instrucciones página 18

English
Assembly
1. Install the pump again in reverse order.
2. Install the appliance again in reverse order.
7. Clearing faults
Attention! Electrocution!
Before clearing faults, remove the mains plug.
Faults
Pump does not start
No air bubbles, the pump is not
pumping
Residual air at the outlet
Dry foam, ineffective skimmer
performance
Moist foam, skimming too strong
High noise generation
For other faults, please contact EHEIM Service.
Possible cause
No mains voltage
Mains plug is not inserted
Impeller is blocked
can occur after the water is changed or
after cleaning
Skimmer is too low
Skimmer is too high
Air volume too low
Inlet and outlet openings dirty
Impeller is dirty
Skimmer is too low
Air volume too high
Impeller is dirty
Air volume too high
18
Remedy
Check the mains
voltage
Check the supply line
Insert the mains plug in the mains
socket
Clean the pump
this ends automatically after approx.
1 day
Position the skimmer higher
Position the skimmer lower
Increase the air intake with the air
adjustment controller
Clean the inlet and outlet openings of
Clean the pump
Position the skimmer higher
Reduce the air intake with the air
adjustment controller
Clean the pump
Reduce the air intake with the air
adjustment controller