Service & Maintenance; Long Term Storage - Belle Group Altrad RT 50 Manual Del Operador

Maintenance
The Belle Group 'RT' range is designed to give many years of trouble free operation. It is, however, important that the simple regular
maintenance listed in this section is carried out.
It is recommended that an approved Belle Group dealer carries out all major maintenance and repairs. Always use genuine Belle Group
replacement parts, the use of spurious parts may void your warranty.
Before any maintenance is carried out on the machine, switch off the engine. If working on a petrol engined machine, disconnect the
HT lead from the sparkplug.
Always set the RT on level ground to ensure any À uid levels will be correctly read. Only use recommended oils (see chart).
Servicing the Engine
Service the engine according to the engine manufacturer's speci¿ cations. Refer to the engine operation and maintenance manual.
Maintenance : Every 8 hours or daily.
1. Check for loose bolt and nuts, retighten if necessary.
2. Check and clean air ¿ lter element, re-lube the element
according to the engine manufacturer's recommendations. If
operating conditions are unusually dusty and severe, ¿ lter
element cleaning should be done more frequently.
3. Check oil level in crankcase of engine and replenish as
necessary. Check oil level in the ramming cylinder as per
following procedures.
- Make sure that the machine has not been run in the last 10
minutes.
- Set the machine on a level surface and remove the oil plug.
- The top surface of the oil must be seen just below the lower rim of
the hole for oil plug. Replenish as necessary.
NOTICE: Care should be taken not to over¿ ll the ramming cylinder with oil. Over¿ lling will cause excessive load on the engine, which
may result in poor or irregular vibration.
Maintenance : First 20 hours of operation
1. Replace the Oil in the Ramming Cylinder
Maintenance : Every 50 hours or weekly
2. Check for loose bolts and nuts. Retighten if necessary.
Maintenance : Every 200 Hours.
3. Change the ramming cylinder oil. Do not over¿ ll.
Fuel and Lubricant
Fuel
Model
Type of Oil
RT50
RT50 Unleaded
RT65 Gasoline
RT66
RT66
RT74
For long term storage, empty the fuel in the carburettor by running the engine with the fuel tap being closed.
The chemical composition of fuel will deteriorate after prolonged storage. When the machine needs to be
stored for a long time, remove all fuel from the fuel tank. Also remove the fuel from the À oat chamber of the
carburettor by draining the fuel out from the drain plug (see diagram).
Clean up oil and dust accumulation on rubber parts.
Clean the base plate and apply a light coating of oil to prevent rust formation.
Cover the machine and store in a dry place.
Service & Maintenance
Engine Crankcase
Capacity Type Of Oil
0.5 Gals SAE
0.5 Gals 10W-30,
0.5 Gals API,
0.8 Gals SG,
0.8 Gals SF/CC,
0.8 Gals CD

Long Term Storage

Engine Capacity
EH09D 0.6 Pints
GX 100 1.2 Pints
GX 100 1.2 Pints
EH12-2D 1.2 Pints
GX120 K1 1.2 Pints
GX120K1 1.2 Pints
22
Ramming Cylinder
Type Of Oil Capacity
SAE 1.5 Pints
10W-30, 1.5 Pints
API, 1.5 Pints
SG, 1.7 Pints
SF/CC, 1.7 Pints
CD 1.7 Pints