Changing The Lamp; The Halogen Lamp - Maglite Mag Charger RE1019 Manual Del Propietário

Changing the Lamp

Section 6
Changing the Lamp

The Halogen Lamp

For the ultimate in flashlight power as well as practicality,
the Mag Charger® Rechargeable Flashlight System features
a halogen, tungsten filament, pin-type replaceable lamp
(bulb). Though small in size, its specifications are large:
6 volts, 8.4 watts and a rating of 50 hours.
C UTION: This bulb is pressurized and C N SH TTER OR EXPLODE,
causing PERSON L INJURY. Wear protective eyeglasses and clothing
when handling; never scratch bulb's glass envelope; never splash bulb
with liquids. Bulb BURNS VERY HOT and C N C USE BURN INJURY
OR HE T OR FIRE D M GE. Remove battery pack and let bulb cool at
least two minutes before handling; avoid operating near materials that
are flammable or prone to heat or drying damage. Dispose of lamp
with care.
Removing the Lamp
1. Holding the largest part of the
flashlight's head, unscrew the face
cap/reflector assembly. It will come
out with the face cap. This is
factory assembled and should not
be taken apart (Fig. 15).
2. Holding the barrel in one hand
(Fig. 16), gently lower the head.
This reveals the lamp for
replacement.
*Lamp life may vary.
*
Fig. 15
Fig. 16
3. Grasp the lamp firmly (Fig. 17) with thumb and forefinger. Pull straight
up until lamp's pins are clear of receptacle. Do not dispose of old lamp in
fire or trash compactor.
C UTION: Lamp is pin-type; do not apply excessive pressure.
4. The New Lamp
Line up the new lamp's pins (Fig. 17) with the 2 holes in receptacle and
apply a straight downward pressure.
Note: The receptacle is spring-loaded and the entire unit (receptacle) will
move down about 1/4 inch. When the glass of the lamp touches the
receptacle, release pressure and let go. Gently wipe bulb surface with a
clean, soft cloth to remove fingerprints.
5. Raise the head of the light (Fig. 15) to its full up position. Reinsert face
cap and reflector assembly and screw on tightly.
Fig. 17
13