Instructions For Use - Speedheater 1100 S Manual De Instrucciones

When heating in vertical angle, turn the
machine around after 2 hours. For keeping
even effect on ir bulbs.
Reset button for
anti-overheat function

INSTRUCTIONS FOR USE

General information before you start
Make sure the protective plates are in facing down before you turn the power tool on.
Never obstruct the airflow through the vented shields. Clean the shields if they get obstructed in any way.
When doing a window restoration, place the Speedheater 1100S-15 in an angle with the help of the angle
support. Begin heating paint and putty for about 1-2 minutes. Putty takes longer to soften than paint and even if
the paint surface has bubbled up, it is good to wait close to 2 minutes for the putty to soften.
The temperature required to remove paint, is significantly less than you may expect. Heat the paint only to
the point when it can be easily scraped off. Indoors 20-30 seconds, outdoors 20-40 seconds. The paint is
ready to be scraped off when it is bubbling and smoking simultaneously.
Variables concerning heatingtime
- Ambient temperature. (Colder temperature will increase time.)
- Wind will increase exposure time. (Outdoor applications.)
- Type of paint. (Acrylic paint needs a shorter heating time.)
- Layers of paint (Many layers will increase heating time.)
Anti-overheat function
The Speedheater Infrared Paint Remover has a shut off function to prevent overheating. The anti-overheat
feature only protects the components of the tool from being overheated. It does
the substrate or protect against fire hazards.
If the anti-overheat function is triggered, power to the unit will be cut and the light on the ON/OFF switch will go
out. The safety switch only comes out approximately 1 mm.
Switch the unit OFF, place it with the heating surface facing up and allow it to cool completely. When cool, reset
the anti-overheat function by pressing the button beneath the power cable.
Start the tool up again, according to the Connecting and heating up instructions. "
not monitor the temperature of
"
11