Troubleshooting Guide - Speedheater 1100 S Manual De Instrucciones

TROUBLESHOOTING GUIDE

Problem Likely cause
Tool does not turn on Tool not plugged in
The anti overheat function is not reset -
The electrical devices in the machine
have been damaged
The fuse has been blown
Tool turned off after it was on Tool overheated and the anti-overheat
function shut the tool off
Fuse blows or circuit breaker trips There has been a short circuit caused
by broken tubes or the power iscord
damaged.
Solution
Plug the cord into a 15 amp outlet
Reset the anti-overheat function by pressing
the button beneath the power cable.
Check the damage and let an authorized
electrician make the necessary repairs.
Change the fuse that goes to the outlet you
are using.
Let the tool cool down for at least 15 minutes
or until it has cooled and press the small
button below the power cord. You will hear
a clicking sound.
Have the tool inspected by an authorized
person to find out where the short circuit is.
Repair the tool with Speedheater System AB
approved components.
15