Extension Cords - Speedheater 1100 S Manual De Instrucciones

O T H E R W A R N I N G S

18. EXTENSION CORDS:

Always use extension cords approved for the required amperage and environmental
conditions or an electric overload may develop, which might lead to a short circuit.
19 . DO NOT EXPOSE THE TOOL TO RAIN:
If the machine gets wet it may cause short circuit.
20. DO NOT ABUSE THE POWER CORD:
Keep cord away from heat, oil, sharp edges or moving parts. Replace damaged cords immediately.
Damaged cords increase the risk of electric shock. Make sure the power cord is not in contact with any of
the hot surfaces on the tool. This could destroy the cord and cause electric shock.
21. TOOL MAINTENANCE: Keep the tool clean and dry. Take special care to ensure that the infrared tubes
and aluminum reflectors are clean and in working order. Dirty tubes and reflectors will reduce efficiency
and can cause fire. Check the power cord, safety shields, and other parts regularly. Replace damaged parts.
The IR tubes are made of quartz glass and must be handled with care. Always use gloves or a rag when
handling the IR tubes. Never touch them with your hands. If an IR tube breaks, immediately switch the
power tool off, pull the plug and replace the tube. Do not operate with only one tube working. Improper tool
maintenance may lead to malfunction, fire hazard, risk of electric shock and thereby personal injury.
22. CHECK DAMAGED PARTS: Before continuing to use this tool, carefully check all safety systems and
other damaged parts to ensure the tool will function properly for the intended task.
The safety system or other damaged parts should be repaired or replaced immediately.
23. DUST PARTICLES: Although this power tool does not create dust itself, scraping the soft paint might
release dust particles that may contain lead. Clean up all removed paint and dust by wet mopping the floors.
Use a wet cloth to clean all walls, sills and any other surfaces where paint or dust is clinging.
Use an environmentally safe cleaning detergent. Place a drop cloth or tarpaulin under the work area to catch
any paint chips or peelings. Wear protective clothing. At the end of each session, put the paint waste and
debris in a double plastic bag, close it with tape or twist ties and dispose of properly. Follow local laws and
regulation. Use respiratory mask and heat protective gloves. Keep interior work area well ventilated.
24. HANDLING THE POWER TOOL: Dropping this tool may cause irreparable damage to the housing and
infrared tubes. IR tubes are the most sensitive parts of this tool and will break if dropped.
Cracked IR tubes and/or damage to the housing void the warranty. It is recommended that a suspension
system be used for removal of paint on exterior walls, which will reduce the risk of dropping the tool and
causing damage to it. Various hands free systems are available from the distributor and/or the dealer -
who sold you the Speedheater Infrared Paint Remover, model 1100 S.
8
Do not use this tool in damp or wet places.
Never use the cord to carry the tool or pull the plug from an outlet.
-