Setting Up For Installation - Dalla Corte DC PRO Manual De Usuario

Setting up for installation

Place the machine on a surface that guarantees a
secure support.
To get ready for set up, make sure you have an ope-
ning of at least 10x10 cm on the support surface (
Pic. 1) to allow connection with systems in the space
below ( B Pic. 1).
The machine should be connected to an appropri-
ate drinking water source compliant with national
laws.
The incoming water pressure should be between
0.1 and 0.6 MPa. If such requirement is not met,
please consult the manufacturer.
32
A tap must be installed between water system and
machine water hose in order to be able to stop
water flow if necessary (
A
Connect a 40 mm diameter drain siphon (
with the local drain system (
The machine is not equipped with any plug since it
is designed to be connected directly to the electri-
cal system – an omnipolar switch compliant with
national laws must therefore be installed (
1
Pic.1).
5
Pic.1)
4
Pic.1).
7
Pic.1).