Turning On The Projector - Christie L2K1500 Guía De Referencia Rápida

Turning On the Projector

1 Complete peripheral connections (with a computer, VCR,
etc.) before turning on the projector.
2
Connect the projector's AC power cord into an AC outlet.
The LAMP indicator lights red and the POWER indicator
lights green.
3
Press the ON/STAND-BY button on the side control
or the ON button on the remote control. The LAMP
indicator dims and the cooling fans start to operate.
The preparation display appears on the screen and the
countdown starts.
4
After the countdown, the input source that was selected
the last time and the Lamp control status icon appear on
the screen.
If the projector is locked with a PIN code, PIN code input
dialog box will appear.
✔Note:
• When the Logo select function is set to Off, the logo will not be shown
on the screen.
• When Countdown off or Off is selected in the Display function, the
countdown will not be shown on the screen.
• If you press the ON/STAND-BY button on the side control or the remote
control during the countdown period, you can skip the countdown and
go to the normal operations. In this case, however, the brightness of the
image needs some time to stabilize after turning on the projector.The
display may flicker after turning on the lamp for the characteristics of
the lamp.This is normal operation and not a malfunction.
Enter a PIN code
Use the Point ed7 8 buttons on the side control or
Number buttons on the remote control to enter a number.
When using side control
Use the Point ed buttons on the side control to select a
number. Press the Point 8 button to fix the number and
move the red frame pointer to the next box. The number
changes to ✳ Repeat this step to complete entering a four-
.
digit number. After entering the four-digit number, move the
pointer to "Set" . Press the SELECT button so that you can
start to operate the projector.
When using remote control
Press the Number buttons on the remote control to enter a
number. When you complete entering a four-digit number,
the pointer moves to "Set" . Press the SELECT button so that
you can start to operate the projector.
If you fixed an incorrect number, use the Point
move the pointer to the number you want to correct, and
then enter the correct number.
If you entered an incorrect PIN code, "PIN code" and the
number will turn red for a moment. Enter the correct
( )
✳✳✳✳
PIN code all over again.
The preparation display will disappear after
20 seconds.
Selected Input Source and Lamp control
✔Note:
•The Lamp replacement icon and the Filter replacement
may appear on the screen depending on the usage
state of the projector.
• When the filter replacement icon keeps appearing
on the screen at turning on the projector for some
time and no action is taken to replace the filter,
the projector will be automatically shut down in 3
minutes after turning on to protect the projector.
• When the Picture in Picture function is set to Mode(1-
5), Mode(1-5), Input source, Lamp control status,
Lamp replacement icon and Filter warning icon will
appear on the screen for 10 seconds.
PIN Code Input Dialog Box
After the OK icon disappears, you can operate the projector.
✔Note:
• If the PIN code number is not entered within
three minutes after the PIN code dialog box
appeared, the projector will be turned off
7 button to
automatically.
•The "1234" is set as the initial PIN code at
the factory
- 16 -
16
Lamp control status
.
020-000410-01 Rev.1 (05-2011)