Turning On The Projector - Christie L2K1000 Guía De Referencia Rápida

Turning On the Projector

1
Complete peripheral connections (with a computer, VCR,
etc.) before turning on the projector.
2
Connect the projector's AC power cord into an AC outlet.
The LAMP indicator lights red and the POWER indicator
lights green.
3
Press the ON/STAND-BY button on the side control
or the ON button on the remote control. The LAMP
indicator dims and the cooling fans start to operate.
The preparation display appears on the screen and the
countdown starts.
4
After the countdown, the input source that was selected
the last time and the Lamp control status icon appear on
the screen.
If the projector is locked with a PIN code, PIN code input
dialog box will appear.
Enter a PIN code
Use the Point ed buttons on the side control or Number
buttons on the remote control to enter a number.
When using side control
Use the Point ed buttons on the side control to select a
number. Press the Point 8 button to fix the number and
move the red frame pointer to the next box. The number
changes to ✳ Repeat this step to complete entering a four-
.
digit number. After entering the four-digit number, move the
pointer to "Set" . Press the SELECT button so that you can
start to operate the projector.
When using remote control
Press the Number buttons on the remote control to enter a
number. When you complete entering a four-digit number,
the pointer moves to "Set" . Press the SELECT button so that
you can start to operate the projector.
If you fixed an incorrect number, use the Point
move the pointer to the number you want to correct, and
then enter the correct number.
If you entered an incorrect PIN code, "PIN code" and the
number will turn red for a moment. Enter the correct
( ✳✳✳✳ )
PIN code all over again.
The preparation display will disappear after
20 seconds.
Selected Input Source and Lamp control
✔Note:
•The Lamp replacement icon and the
Filter replacement or the Filter cartridge
replacement icon may appear on the
screen depending on the usage state of
the projector.
PIN Code Input Dialog Box
After the OK icon disappears, you can operate the projector.
✔Note:
• If the PIN code number is not entered
within three minutes after the PIN code
dialog box appeared, the projector will be
turned off automatically.
•The "1234" is set as the initial PIN code at
button to
7 the factory
- 16 -
16
Lamp control status
.
CAUTION ON HANDLING PIN CODE
If you forget your PIN code, the projector
can no longer be started. Take special care
in setting a new PIN code; write down the
number and keep it on hand. Should the
PIN code be missing or forgotten, consult
your dealer or service center.
020-000409-01 Rev.1 (08-2011)