AERMEC Novatherm TRS251 Manual De Instrucciones página 42

2.
Mode key: press the MODE key to select the RA-OA-FR (ea)-sa setting-CO
Remark:
The CO symbol appears when the CO
2
The humidity symbol appears when the "temperature and humidity sensor" is connected. ERV runs at boost speed when humidity higher
than setting value. Under "humidity control" mode, users can set the setting humidity by pressing ▲ and ▼ keys. The setting range
is 45% ~ 90%. And the Dial switch SW4-3 on the PCB should be switched ON to switch from CO
function.
3.
Adjusting the air flow: access the SA (supply) or RA (return) temperature visualisation. The user can set the return air flow
in RA mode, and the supply air flow in SA mode, by pressing the ▲ and ▼ keys. There is a choice of 10 speed levels.
4.
Checking the error code: from the main screen, press the SET key briefly to check the fan error code. Refer to the table
below.
Speed 3
Error Alarm
5.
Setting the bypass: when the bypass is active, the Δ bypass signal appears (disappearing when the bypass is deacti-
vated). Refer to the chapter with the detailed explanation of the settings.
SA Temperature Setting
sensor is connected. ERV runs at boost speed when CO
2
EN
status or humidity control.
2
Current Humidity
Setting Humidity
concentration higher than setting value.
2
control function to humidity control
2
Speed 5
CODICE
Error Alarm
E1 Fresh air temperature sensor error
E2
E3 Error on return air temperature sensor
E4 Error on expelled air temperature sensor
E5
E6 Supply air temperature sensor error
E7
E8
CO Concentration
2
Speed 10
ERRORE
EEPROM error
Communication error
Expulsion fan error
Supply fan error
42