Publicidad
Idiomas disponibles
Idiomas disponibles
l_[e]_.S]l
[]
CONNECTIONS
NOTES:
• Do not plug n the power plug into an outlet until all connections
have been completed
• Check the channels and be sure to connect left to left (L--white),
right to right (R--red)
• Inserl the power plug securely
An incomplete
connection
will cause noise to occur
• After unplugg ng the power supply cord, wait about 5 seconds before plugging
it back in
• Be sure to connect the speaker cords between
the speaker terminals
and the speaker systems
with the
same polarities {+ to +,
to
If the polarities are switched,
the sound at the center will be weak, the
position
of the different
instruments
will be unclear, and the stereo effect will be lost
• Do not bundle the (pin plug} connection
cables together
or place them close to other electrical
products
such as Ws since this may cause hum or other noise
Connecting
the speaker
systems
• COn_lect the speaker system for the left
channel (the left side as see_ from the
front) to the "L" teEminals, the speaker
system for the right channel to the "R"
terminals
• Be sure to use speaker systems with an
impedance
of 6 ££uhms or greater
Speakers
CD receiver
[USC-107
Rear panel]
[D-107 Side panel]
©
©
Speakers
IUSC-107
Rear panel]
Speaker cord
Power supply cord
AC 120V/60
Hz
D
Speakercord
SystemcaMe
I
I
Subwoofer
[USW-107
Rear panel]
71
II
Speake[cord
Speakelcord
MD ecorder
or
Optical
Cassetce deck
connect on came
IN
MD ecorder of
CD recorder
• The source selected
by pressing
the
FUNCTION button is output from the AUX OUT
terminals
If thefunction
is set to "AUX",
however, the sound of the component
connected
to the AUX IN terminals
is not
output
from the AUX OUT terminals
• Do not press the FUNCTION button while
recording a D-107 source on an external
recorder
NOTE:
Pressing the FUNCTION button while
recording a Dq07 source o_ an external
recorder will switch
the source being
recorded
ANTENNA
TERMINALS
--
FM outdoor antenna
AM loop anten/a
6
Publicidad
