Spraying Technique - Titan Airless 1650e Serie Instrucciones De Uso

Starting operation
Security Code Screen
The Security Code screen allows the
user to set a four digit security code to
prevent unauthorized use of the sprayer.
If a security code has been set, the
control system display will ask for the
code at startup. If the correct code is entered, the display will show
the Main Screen and the sprayer will operate. If the wrong code is
entered, the display will continue to ask for the correct code and the
sprayer will not work. To set or change the security code, press the
#2 key.
i
If the sprayer is new, no security code is set and the
Main Screen will appear at startup. When setting a
security code for the first time, the "Enter Old Code
Number" screen will appear, and you will need to
enter "1111".
Enter the old security code number to
access the screen that allows the code
change. If the wrong code is entered,
the display will continue to ask for the
correct code and the security code
cannot be changed.
Enter the new security code. Once the
new code is entered, the display will
automatically ask that the new code be
re-entered for verification. If the same
new code is re-entered, the display will
confirm that the new code has been
accepted and return to the Main Screen.
If the new code is re-entered incorrectly,
the display will return to the "Enter New Code Number" screen and
the process will repeat.
If you forget or misplace your security code, you can contact Titan
customer service for assistance.
i
To inactivate the security function, enter "1111" at
the "Enter New Code Number" screen (this is the
default code that leaves the sprayer unlocked). As
a result, the Main Screen will appear at sprayer
startup.
Prime Screen
The Prime screen appears when the
pressure control knob is set at the "MIN"
setting.
Rapid Clean Screen
The Rapid Clean screen appears when
the pressure control knob is set at the
RAPID CLEAN position and the PRIME/
SPRAY valve is in the PRIME position.
i
If there is no action at any menu screen for 30
seconds, the display will go back to the Main Screen.
GB
SECURITY CODE
MENU-1 CHANGE-2
ENTER OLD CODE
NUMBER
ENTER NEW CODE
NUMBER XXXX
RE-ENTER NEW
NUMBER XXXX
NEW CODE NUMBER
ACCEPTED
PRIME
RAPID CLEAN
14
5.

Spraying technique

Injection hazard. Do not spray without the tip guard
in place. NEVER trigger the gun unless the tip is
completely turned to either the spray or the unclog
position. ALWAyS engage the gun trigger lock
before removing, replacing or cleaning tip.
The key to a good paint job is an even coating over the entire surface.
Keep your arm moving at a constant speed and keep the spray gun at
a constant distance from the surface. The best spraying distance is 25
to 30 cm between the spray tip and the surface.
Keep the spray gun at right angles to the surface. This means moving
your entire arm back and forth rather than just flexing your wrist.
Keep the spray gun perpendicular to the surface, otherwise one end
of the pattern will be thicker than the other.
Trigger gun after starting the stroke. Release the trigger before
ending the stroke. The spray gun should be moving when the trigger
is pulled and released. Overlap each stroke by about 30%. This will
ensure an even coating.
25 - 30 cm
i
If very sharp edges result or if there are streaks in the
spray jet – increase the operating pressure or dilute
the coating material.
Spraying technique
25 - 30 cm
25 - 30 cm
Performance Series 1650e