Technical Data; Transportation; Transportation In Vehicle; Painting Material Setup - Titan Airless 1650e Serie Instrucciones De Uso

Description of unit
3.5

Technical data

Voltage:
Max. current consumption:
Power cord:
Acceptance capacity:
Max. operating pressure:
Volume flow at 12 MPa
(120 bar) with water:
Max tip size:
Max. temperature of the
coating material:
Max viscosity:
Weight:
Special high-pressure hose:
Dimensions (L X W X H):
Altitude:
Max sound pressure level:
* Place of measuring: 1 m in distance from the unit and 1.6
m above the floor, 12 MPa (120 bar) operating pressure,
reverberant floor.
3.6

Transportation

Pushing or pulling the unit
Pull out the handle (Fig. 2, Item 1) until it will come no further. Insert
the handle – push the buttons (2) on the spars, and then push in the
handle.
2
3.7

Transportation in vehicle

Secure the unit with a suitable fastening.
100-110 Volt AC, 50 Hz
15 A / 20 A
3 x 1.5 mm – 6 m or 4.6 m
2
2000 Watt
221 bar (22,1 MPa)
5.0 l/min
0.039 inch – 0.99 mm
43°C
30.000 MPa·s
50 kg
DN 6 mm, 15 m, connection
thread M 16 x 1.5
632 x 568 x 743 mm
This equipment will operate
correctly up to 2000 m above mean
sea level
80 dB (A) *
1
2
GB
3.8 Paint material setup
i
This sprayer comes with a filter assembly installed.
If you plan to spray with untextured painting
materials, leave the filter installed.
3.9

Textured material setup

i
This sprayer comes with a filter plug that should be
put in place of the filter whenever spraying textured
materials. Follow these steps to remove the filter
and install the plug.
1. Loosen and remove the filter housing (1) by hand.
2. Remove the adapter spring (2), filter (3), bearing ring (4) and
spring (5) from the housing (7).
3. Make sure the O-ring (6) is still in place. Thread the filter plug
(8) into the housing until secure.
i
The filter plug should be hand-tightened, but make
sure it is seated fully into the filter housing.
1
2
3
4
5
i
If using this sprayer with textured materials, it is
important that the filter inside of the spray gun be
removed. See section 8.3.
i If the sprayer will be used for spraying textured
products, removal of the inlet screen in the foot
valve may be necessary. This will allow proper
priming and flow of the textured product. See
section 8.4.
10
8
6
7
Performance Series 1650e