Nolan N100-5 Special N-Com Seguridad E Instrucciones página 23

WARNING
- Make sure the VPS operates correctly by activating and deactivating it (see
instructions above).
If necessary, repeat the above-mentioned steps.
- If the VPS opening and closing mechanisms are not working properly or if such
mechanisms get damaged, please contact a Nolangroup authorized dealer.
- Do not use the helmet if the VPS has not been assembled properly.
- Since the VPS does not assure you the same protection as the one provided by
the visor, it has to be used only when the helmet visor is lowered.
REMOVABLE INNER COMFORT PADDING
The removable comfort padding consists of:
- a liner
- roll neck
- pads of the side cheek pads (right and left)
All components can be completely removed and washed.
The cheek pads are also characterised by removable inner expanding foam padding.
Deactivate the VPS and lift the helmet chin guard to remove and/or install the comfort
padding (see instructions above).
1 CHEEK PAD DISASSEMBLY
1.1 Open the chin strap (see specific instructions) and remove the chin strap band
from the elastic loops on the roll neck, and from the slot of the windproof strap that
is embedded in the cheek pad (Fig. 14).
1.2 Pull the front of the left cheek pad towards the inside of the helmet to release
the three buttons on its back (Fig. 15). Completely remove the padding of the left
cheek pad from the helmet.
1.3 Repeat these steps with the right cheek pad padding.
2 DISASSEMBLY OF THE INNER EXPANDING FOAM PADDING OF THE CHEEK PADS
To make it easier to wash the inner comfort padding components, the cheek pads of
the helmet are fitted with inner expanding foam padding that can be removed from the
fabric lining. To remove the padding, proceed as follows after removing the cheek pads
from the helmet (see instructions above).
2.1 Unhook the three eyelets "A" of the rear frame of the left cheek pad next to the
three snap buttons (top, front and rear) on its back (Fig.16).
2.2 Take the top "B" and bottom "C" flaps of the frame out of the respective loops on
the back of the frame (Fig.16).
2.3 Gently remove the inner expanding foam padding from the fabric lining of the
cheek pad (Fig.17).
2.4 Repeat these steps with the right cheek pad padding.
N100-5 / PLUS
INSTRUCTIONS FOR USE
23