Ventilation System - Nolan N100-5 Special N-Com Seguridad E Instrucciones

WARNING
After adjusting the position of the liner, wear and fasten the helmet to check the
correct adjustment of the chin strap (see attached label), the correct positioning of
the helmet on the head in the riding position and the taking off (see "SAFETY AND
USE INSTRUCTIONS" above).
WIND PROTECTOR
(Available as standard or accessory/spare part).
This accessory allows improved helmet performance under certain conditions of use.
The Wind Protector reduces unpleasant infiltrations of air under the chin.
See Fig. 26 for assembly and disassembly operations.

VENTILATION SYSTEM

The ventilation system of the helmet consists of:
Lower Ventilation System
It allows ventilation in the mouth area and conveys the air directly on the visor reducing
fogging.
See Fig.27 for opening and closing operations.
Top Ventilation System
The innovative AIRBOOSTER TECHNOLOGY system channels the air coming from
the front air intake by directing it in the top area of the rider's head without any dis-
persion.
See Fig.28 for opening and closing operations.
Rear Ventilation System
It allows warm and stale air to flow out ensuring an optimum comfort inside the helmet
(Fig.29).
N-COM - NOLAN COMMUNICATION SYSTEM SET UP
(Available depending on the product version).
Your helmet is factory-preset to be equipped with the N-Com communication system.
During the communication system installation (see the specific instructions contained
in the N-Com kit), it will be necessary to remove from the helmet the foam material fillers
located in the polystyrene cheek pads next to the N-Com earphones seats.
The above-mentioned fillers should only be removed if the helmet is used with an
N-Com compatible system installed.
N100-5 / PLUS
INSTRUCTIONS FOR USE
27