Use Of Additional Accessories - Evolution STEALTH RAGE 3-S Instrucciones Originales

Fig. 41
Fig. 42
(8.12)
USE OF EVOLUTiON ACCESSORiES.
Supplied as original equipment on the RAGE3+, RAGE3-S+
and RAGE3-S300. All accessories can be purchased from
Evolution power Tools.
(8.13)
DUST BAG
A Dust Bag can be fitted to the extraction port at the rear of
the machine. The Dust Bag is for use when cutting wooden
materials only.
• Slide the Dust Bag over the dust extraction port, ensuring
that the spring clip grips the port holding the Dust Bag
securely in place. (Fig. 41)
Note: For operational efficiency empty the Dust Bag when it
becomes 2/3 full. Dispose of the contents of the Dust Bag in an
environmentally responsible way. It may be necessary to wear a
dust mask when emptying the Dust Bag.
Note: A workshop vacuum extraction machine can be
attached to the dust extraction port if required. Follow the
manufacturers instructions if such a machine is fitted.
WARNiNG: Do not use the Dust Bag when cutting
metallic materials.
Extraction port blanking plug
Use the blanking plug in place of the dust bag when cutting
steel based materials.
Extraction port adaptor tube
Use the Adaptor Tube to connect the extraction port of the
machine to suitable commercial workshop vacuum extraction
equipment (not supplied) which have Ø30mm internal bore
hoses or inlet ports.
WORKpiECE SUppORT BARS
Workpiece Support Bars can be fitted to either
or both sides of the machines base as required.
• Right Hand side. Loosen the support retaining screw located in
the top front of the machines base.
• Insert the workpiece supports bars into the retaining holes in
the base. Push fully home to ensure positive location.
34
www.evolutionpowertools.com
(Fig. 42)