Grizzly ERV 1400-35 Manual De Instrucciones página 50

GB
customer service centre.
• If the blades no longer cut cor-
rectly or if the motor is over-
loaded, check all the parts of
your equipment and replace
the worn parts. If a more exten-
sive repair is required, contact
a customer service centre.
Use:
• CAUTION – A very sharp tool.
Avoid cutting your fingers or
toes. While working always
keep your feet and fingers well
away from the cutting cylinder
and the ejector opening. There
is the danger of serious injury!
• Do not operate the imple-
ment while it is raining, in poor
weather conditions and when
the surrounding area and lawn
are wet. Operate the imple-
ment only during daylight hours
or with bright lighting.
• Do not operate the implement
if you are tired or are lacking in
concentration and after having
drunk alcohol or taken medi-
cine. Always take a work break
in due time. Approach the work
with common sense.
• Familiarize yourself with the
terrain and remain focused on
the potential hazards that you
could miss on account of the
motor noise.
• Always maintain a secure foot-
ing while working, especially on
a sloping terrain. Always work
across slopes - never up and
down! Be particularly careful
when changing the travelling
direction. Do not work on very
steep slopes.
50
• Always guide the implement
at a walking pace with both
hands on the handle. Be es-
pecially careful when you turn
the implement around or draw
it towards you. Danger of stum-
bling!
• Start or actuate the starting
lever with care and in conform-
ity with the directions in these
Instructions.
• Do not tilt the implement when
starting, other than it has to be
lifted. In this case tilt the imple-
ment only to the extent that
is absolutely necessary and
always lift the implement on
the side that is opposite to the
operator.
• Never operate the implement
without the attached collection
bag or impact protector. Dan-
ger of injury! Always keep well
away from the ejector opening.
• Do not operate the implement in
the vicinity of inflammable liquids
or gases as this could give rise
to the danger of a fire or explo-
sion.
Work intervals:
• After the implement has been
turned off, the cutting cylinder
will continue to rotate for a few
seconds. Keep hands and feet
well away.
• Only remove plant parts when
the implement is standing com-
pletely still. Ensure that the
grass ejector opening is clean
and free.
• Switch off the power when the
implement is to be transported,
lifted or tilted and when tra-