LaserLiner SmartCross-Laser Manual De Instrucciones página 12

Checking the vertical line
Position the device about 5 m from a wall. Fix a plumb bob
with a line of 2.5 m length on the wall, making sure that
the bob can swing freely. Switch on the device and align the
vertical laser to the plumb line. The precision is within the
specified tolerance if the deviation between the laser line
and the plumb line is not greater than ± 2.5 mm.
Checking the horizontal line
Position the device about 5 m
from a wall and switch on the
cross laser. Mark point B on
the wall. Turn the laser cross
approx. 2.5 m to the right
and mark point C. Check whether the horizontal line from
point C is level with point B to within ± 2.5 mm. Repeat
the process by turning the laser to the left.
!
Regularly check the calibration before use, after
transport and after extended periods of storage.
Technical data
Self-levelling range
Accuracy
Operating range (depending
on room illumination)
Laser wavelength
Laser class
Power supply
Operating time
Operating temperature
Storage temperature
Dimensions (W x H x D)
Weight (incl. batteries)
12
EN
B
Subject to technical alterations. 04.17
± 5°
± 0.5 mm / m
10 m
650 nm
2 / < 1 mW
2 x 1.5 V alkaline
batteries (type AA, LR6)
15 hours
(alkaline batteries)
0 °C ... +40 °C
-10 °C ... +70 °C
55 x 85 x 75 mm
260 g
2,5 m
C