Preparing The Dispenser; Legal Information; Technical Data - Ottobock 616S5-1 Instrucciones De Uso

11) After 15 min to 20 min, remove the liner and turn it inside-out.
12) NOTICE! Work carefully when sanding in order to avoid damage to the silicone materi­
al of the liner.
Trim the BetaSil with scissors or sand it with a sanding sleeve (see fig. 13).
Then sand with the sanding brush (see fig. 14).
Finally smooth with the polishing roller (see fig. 15).

5.3 Preparing the Dispenser

For homogenous mixing of the two silicone components, a static mixer is threaded onto the cart­
ridge. Then the cartridge is inserted into the dispenser that pushes out the silicone.
Vulcanisation of the silicone begins as soon as the two components mix in the static mixer. When
work interruptions (e.g. to change the cartridge) are shorter than the processing time of the silic­
one, the static mixer can continue to be used. Partly emptied cartridges can be resealed with the
cover cap. The silicone in the cartridge remains unmixed and can still be used. The static mixer
must be disposed of after the work is complete.
Required tools and materials:
>
Dispenser, Static Mixer, BetaSil Cartridge
1) Rotate the cover cap on the cartridge anticlockwise by 90° and pull it off (Fig. 5 and 6).
2) Apply the static mixer to the cartridge and lock it with a 90° clockwise rotation (Fig. 7).
3) Pull the dispenser plunger back to the stop.
4) Put the cartridge into the dispenser with the notch at the bottom (Fig. 8).
5) Lock the dispenser.
6) Push the plunger into the cartridge by operating the handle until the static mixer fills with silic­
one.
7) If the cartridge is not empty after completing the work, reseal it with the cover cap.
6 Disposal
This product may not be disposed of with regular domestic waste in all jurisdictions. Disposal that
is not in accordance with the regulations of the country where the product is used may have a det­
rimental impact on health and the environment. Please observe the information provided by the
responsible authorities in the country of use regarding return and collection processes.

7 Legal Information

All legal conditions are subject to the respective national laws of the country of use and may vary
accordingly.
7.1 Liability
The manufacturer will only assume liability if the product is used in accordance with the descrip­
tions and instructions provided in this document. The manufacturer will not assume liability for
damage caused by disregard of this document, particularly due to improper use or unauthorised
modification of the product.

8 Technical Data

Reference number
Cartridge content per component [ml]
Shore hardness [shore A]
Material
Storage temperature [°C]
Processing temperature [°C]
Processing time [min]
10 | Ottobock
616S5=1, 616S6=1
75
10
2-component silicone
max. 25
23
5