Descargar Imprimir esta página

Size Selection; Legal Information - Ottobock 453D2 Instrucciones De Uso

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 8
inside the sock is provided with a polymer gel layer.
The polymer gel is extruded with a medical mineral oil, which has a beneficial effect on the skin.
During wearing the oil will slowly diffuse from the gel and thus keep the skin smooth.
Due to the viscous nature of the gel, disturbing friction, pressure and weight bearing are reduced.
The blended fabric of the sock keeps the skin dry and does not increase body temperature.
The Derma Seal Trans Ped offers high wearing comfort due to its fabric and the inner polymer
gel layer.
4 Application and care
The Derma Seal Trans Ped stump sock is pulled over like a normal sock. The polymer gel should
be placed directly on the skin of the residual limb. In this way its medical oil will ensure optimal
care of the skin and keep it smooth.
After one day's use the stump sock should be washed by hand in warm water (approx. 30 °C)
using a mild detergent. Thoroughly rinse with clear water. Do not wring.
The drying process in the area of the special polymer gel layer may last longer. To reduce the time
of drying, the stump sock may be pre-dried in a towel immediately after washing. Then it should
be laid flat on a drying frame or on a terry towel for complete drying.
The Derma Seal Trans Ped stump sock should not be worn in a wet condition.
Any tackiness of the polymer gel can be reduced by slightly dusting the gel layer with talcum
powder.
For better hygiene of the residual limb skin it is recommended to remove the Derma Seal Trans
Ped stump sock for a few hours each day, thus providing the skin with fresh air.

5 Size selection

Article number
453D2=N
453D2=XL

6 Legal information

All legal conditions are subject to the respective national laws of the country of use and may vary
accordingly.
6.1 Liability
The manufacturer will only assume liability if the product is used in accordance with the descrip-
tions and instructions provided in this document. The manufacturer will not assume liability for
damage caused by disregard of this document, particularly due to improper use or unauthorised
modification of the product.
6.2 CE conformity
The product meets the requirements of Regulation (EU) 2017/745 on medical devices. The CE
declaration of conformity can be downloaded from the manufacturer's website.
4
Size
Length
Standard
22 cm
extra long
50 cm

Publicidad

loading