Mitsubishi Heavy Industries SC-SL3NA-AE Manual Del Propietário página 28

Function Settings
The timeout for turning OFF the backlight, validating or invalidating of the auto mode button and locking or un-
locking the individual functions of the remote controller are set.
When changing the Function Settings, follow the following steps.
1. Press the FUNCTION SETTING button on the MAIN MENU.
[Function Setting screen]
2
3
6
2. Select the Backlight Timeout time using the ▲▼ buttons. (Factory default : 10)
Time from the last operation on the touch panel until the monitor backlight turns OFF can be selected.
3. Select the Brightness using the ▲▼ buttons. (Factory default : 7)
Brightness for the monitor backlight can be selected.
4. Change "Language". Pressing this button allows you to select the desired language.
Please contact the shop where the unit was purchased.
5. Change "SL-Mode". Use it when set the communication system (Factory default : New).
Usually, this is not necessary to change it.
If setting is incorrect, this may cause no communication with a part or all of air conditioners.
Please contact the shop where the unit was purchased.
6. Press the Change button.
You can specify the folder to transfer the calculated data to USB memory. (SC-SL3NA-BE
7. Press the "Valid" or "Invalid" button for the Auto Mode. (Factory default : Invalid)
This enables or disables the AUTO button on the GROUP SETTINGS screen and CHANGE All screen.
If you set Auto Mode to INVALID,
This function can be applied to the outdoor units, which are the cooling / heating free multi KXR, GHP-R
series or later and PAC.
For other than the outdoor units above, please do not use Auto Mode.
Please contact the shop where the unit was purchased.
8. Press the "Valid" or "Invalid" button for the Fan Powerful Mode. (Factory default : Invalid)
This enables or disables
If you set Fan Powerful mode to Invalid,
Please contact the shop where the unit was purchased.
9. Select the "Closed" or "Open" for the Malfunction Output (Normal). (Factory default : Closed)
You can choose "Closed" or "Open" status for malfunction output during normal operation of air condition-
ing unit.
Contact your service representative or installer for further information.
10. In case of managing one air conditioner with plural center consoles, regarding the prohibition set-
ting of remote controller if the different settings from plural center consoles are done on this air
conditioner, it may cause that this air conditioner cannot start operation by the remote controller
despite the intention of user. Accordingly, in this case, be sure to make permission/prohibition set-
ting only with the master center console, not with slave center consoles.
(Factory default :Valid)
In addition, make this setting to "valid" when the external input wiring such as emergency stop input are
connected to this central control.
Please contact the shop where the unit was purchased.
4
7
5
8
9
13
Auto button is not shown on the screen.
button on the GROUP SETTINGS screen and CHAGE All screen.
button is shown on the screen.
– 27 –
Page 7
[Detail Setting screen]
10
11
12
only)Note