Mitsubishi Heavy Industries SC-SL3NA-AE Manual Del Propietário página 34

"SL-0X-self address duplica-
tion error was detected."" SL-
0X- self transmission data read
error was detected."" SL-0X-
data transmission error was
detected." message appears.
Error messages other than
the above are displayed.
The room temperature display
does not change from "--".
When you select "Valid" for
the Individual Lock/Unlock on
the Function Setting screen,
the function of permitting
and prohibiting the individual
operation of the remote con-
troller do not work.
In case that operating condi-
tion of a part or all of air
conditioners which are set to
a group, does not display.
The screen of this central
control is not returned to nor-
mal display even if you press
the reset switch.
Caution that performing of the monthly calculation (SC-SL3NA-BE only)
• We can not compensate when monthly calculation was not possible by the truble of this Central Control.
• Because the monthly calculation of power consumption by this data does not conform to OIML, it cannot be
applied to public business.And also there are no guarantees concerning the results of the calculations.
• Please prepare the PC, spreadsheet such as EXCEL, a printer, a voltmeter, the gas fl ow meter that are re-
quired for calculation.
Contact the shop where the unit was purchased. (Re-check the communications line connections of the
units.)
Perform operations according to the messages on the screen or turn the power off and then on (power
supply reset).
If the message appears again, contact the shop where the unit was purchased.
When the intake-air temperature is 0°C or less, "--" is displayed.
When it differs from the display of remote controller, contact the shop where the unit was purchased.
This function can be applied to the indoor units, which are the model KXE4 or later, and to the remote
controller, which is the model RC-E1 or later.
Make sure to select "Invalid" for the Individual Lock/Unlock on the Function setting screen.
There may be inadequacy for communication line or the setting of this center console.
Please contact the shop where the unit was purchased.
This may possible that the central control or power system has malfunction.
Please contact the shop where the unit was purchased.
– 33 –